X-Line grayscale calibration

Grayscale calibration must be performed on the X-Line system either weekly or after an extended period of system inactivity.


If calibration is overdue, this will be indicated in the PILOT Inspect operating software.


A grayscale calibration tool is shipped with the X-Line system at the time of purchase.


If you need a replacement tool, please contact your local GOEPEL representative or get in touch with us at help@goepelusa.com.
Grayscale calibration tool case

Grayscale calibration tool (inside case)




Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.

Still need help? Contact Us Contact Us